![]() The system is configured for synchro heading but the XYZ synchro signals are not present or are out of specification.Ī. Check jumper selection in the mating connector assembly (refer to paragraph 2.9, table 2-2). If the jumper does not agree with user selection, the error message remains displayed and the status will change to “fatal error”.Ĭ. That corresponds to Stormscope system antenna location.ī. This may occur the first time the system is powered on in a new installation or after the configuration wiring is changed.Ī. Fault will clear automatically if interference subsides.Īntenna location (top/bottom, determined by processor wiring) changed since the system was last powered up. If airborne near Annapolis, maybe ground transmitter.Ĭ. Check for the presence of noise using a built-in NOISE MONITOR or a WX-SM skinmapper.ī. Main Processor or Antenna in a noisy location. Most of the time, aircraft noise is to blame. Weather mapping is inhibited.Ĭ Fault will clear automatically if interference subsides.ĭ. Invalid test strikes, antenna in a noisy location, or faulty antenna. most of the time, aircraft noise is to blame. Fault will clear automatically if interference subsides.Į. ![]() If airborne near Annapolis, maybe ground transmitter.ĭ. Check for the presence of noise using a built-in NOISE MONITOR or a WX-SM skinmapper.Ĭ. No test strikes, antenna in a noisy location, or faulty antenna. Use test cable to isolate between antenna and aircraft wiring. Check antenna wiring for opens and shorts.ī. Software upgrade to 1.04 for noise reduction in composite aircraft.Īntenna or Antenna wiring Weather mapping is inhibited.Ī. Contact us for error codes not listed.ĮRROR 08. Errors may be worded similarly, but not exactly. Each MFD will show the information consistent with the capabilities of that particular display. The many capabilities of the WX-500 allow MFD manufacturers to create screens compatible with the various functions of their display. ![]() Access the fault codes per the instructions in the pilot manual for your MFDĪll WX-500 functions are controlled through the MFD which is wired to be the master control for your WX-500. On failed operation it is the test signal between the processor and antenna if it is on the test is not running On failed operation something has failed internal or external Off failed operation it is not booting up The best starting point for troubleshooting the WX-500 is with the LEDs on the front of the processor and the error codes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |